On Wed, Oct 24, 2018 at 3:34 AM Prabhakar Kushwaha <prabhakar.kushw...@nxp.com> wrote: > > > > -----Original Message----- > > From: U-Boot <u-boot-boun...@lists.denx.de> On Behalf Of Jeremy > > Gebben > > Sent: Wednesday, September 19, 2018 3:20 AM > > To: u-boot@lists.denx.de > > Cc: Joe Hershberger <joe.hershber...@ni.com>; Shaohui Xie > > <shaohui....@freescale.com>; York Sun <york...@freescale.com> > > Subject: [U-Boot] [PATCH 2/3] net: phy: aquantia: add firmware loading > > support > > > > Aquantia phys have firmware that can be loaded automatically from storage > > directly attached to the phy or via MDIO commands. > > Add support for loading firmware from either a file or a raw location on an > > MMC device. > > > We have integrated your patch series. Now we have one AQR FW: > AQR-G3_v4.2.C-AQR.cld > How to flash this FW on Aquantia card ?
Not sure what you are asking here. My patches don't provide support for programming the persistent storage attached to the aquantia phy on NXP's development boards. To program the firmware, put the AQR-G3_v4.2.C-AQR.cld file in a directory on a partition that uboot can read. Then set PHY_AQUANTIA_FW_PART to the parition code (for example "0:2") and PHY_AQUANTIA_FW_NAME to the full path to the firmware file (for example "/boot/AQR-G3_v4.2.C-AQR.cld") If you #define DEBUG in aquantia.c, you should get some output as the code loads the file and verifies checksums. > When my u-boot will boot, does Firmware programming process will trigger by > itself or do we need to execute some command on u-boot prompt ? Firmware programming should happen automatically when the phy is configured. Does that help? Jeremy > > --pk _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
