Kumar Gala wrote: > From: Jerry Huang <chang-ming.hu...@freescale.com> > > To support multiple block read command we must set abort or use auto > CMD12. If we booted from eSDHC controller neither of these are used > and thus we need to reset the controller to allow multiple block read > to function. > > Signed-off-by: Jerry Huang <chang-ming.hu...@freescale.com> > Signed-off-by: Roy Zang <tie-fei.z...@freescale.com>
Tested successfully on mx51evk. Acked-by: Stefano Babic <sba...@denx.de> Regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
