On 08/15/2018 12:28 PM, Ley Foon Tan wrote: > On Wed, Aug 15, 2018 at 6:13 PM, Marek Vasut <[email protected]> wrote: >> On 08/15/2018 08:01 PM, Ley Foon Tan wrote: >>> Move reset manager node to top, so reset driver can be load before >>> other drivers. Peripheral drivers have dependency on reset framework >>> to reset the hardware. >>> >>> Signed-off-by: Ley Foon Tan <[email protected]> >> >> This will break the next time you sync DTs with Linux, NAK. >> The reset manager should just load when it's needed by other drivers. If >> it doesn't work that way, something is seriously broken and that is what >> needs to be fixed. > Yes, seem that it doesn't load the reset manager driver automatically > when other driver depend on it. > Notice this issue when enable reset framework in GPIO, GPIO driver is > loaded at very beginning before go to command prompt. > Found this can work in SPL, but not in U-boot (load reset manager > driver automatically).
That's probably because you're using the reset in .bind instead of .probe , as it should be used ? .bind is ONLY for binding the driver with the DM core. -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
