The L4SP and MMC clock precalculation is specific to Gen5, it is not
needed on Arria10/Stratix10. Isolate it to Gen5 until there is a proper
clock driver for Gen5, at which point this will go away completely.
Signed-off-by: Marek Vasut <ma...@denx.de>
Cc: Chin Liang See <chin.liang....@intel.com>
Cc: Dinh Nguyen <dingu...@kernel.org>
Cc: Ley Foon Tan <ley.foon....@intel.com>
---
arch/arm/mach-socfpga/clock_manager.c | 2 ++
1 file changed, 2 insertions(+)
---
V2: No change
diff --git a/arch/arm/mach-socfpga/clock_manager.c
b/arch/arm/mach-socfpga/clock_manager.c
index 59ede59b59..9f3c643df8 100644
--- a/arch/arm/mach-socfpga/clock_manager.c
+++ b/arch/arm/mach-socfpga/clock_manager.c
@@ -42,9 +42,11 @@ int cm_wait_for_fsm(void)
int set_cpu_clk_info(void)
{
+#if defined(CONFIG_TARGET_SOCFPGA_GEN5)
/* Calculate the clock frequencies required for drivers */
cm_get_l4_sp_clk_hz();
cm_get_mmc_controller_clk_hz();
+#endif
gd->bd->bi_arm_freq = cm_get_mpu_clk_hz() / 1000000;
gd->bd->bi_dsp_freq = 0;
--
2.16.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
