In my opinion, you could use kermit to send your binary file into ram, for instance 0x200000,via serial connection, and then use u-boot command "go 0x200000"
Hope that helps you. Best, regards Rui On Wed, Mar 17, 2010 at 1:26 AM, James Smith <bb...@yahoo.com> wrote: > Hi, > > I am quiet new with embedded linux so I was wondering if someone can help me > with my issue. I am trying to load a c code on the mpc5121e processor found > on the ADS5121 board. The only connection between my board and my host (Linux > PC) is a serial cable and an Ethernet cable. I am trying to turn on the LEDs > on the board, but for some reason I am not able to debug my code. I have been > told that I either have to purchase an EthernetTAP or a USBTAP, or I should > try to load the code in U-Boot. So I was wondering if someone can tell me how > to load my code in U-Boot. > Thank you. > > > > > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
