On Thu, Jul 26, 2018 at 12:35 PM, Icenowy Zheng <icen...@aosc.io> wrote: > > > 于 2018年7月26日 GMT+08:00 下午3:02:50, Jagan Teki <ja...@amarulasolutions.com> 写到: >>On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icen...@aosc.io> wrote: >>> This patchset trys to add support for Allwinner H6 SoC to U-Boot. >>> >>> Allwinner H6 is a quite new Allwinner SoC, with several parts changed >>a >>> lot (memory map, DRAM controller, CCU, so on). The position which SPL >>> will be loaded (SRAM A1) also changed to 0x20000. >>> >>> The Pine H64 board support comes with this patchset, as this is the >>> first H6 board that I can get (being early bird). >>> >>> Icenowy Zheng (13): >>> sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS >>> sunxi: add basic memory map definitions of H6 SoC >>> sunxi: change RMR64's RVBAR address for H6 >>> sunxi: change ATF position for H6 >>> sunxi: add config for SPL at 0x20000 on H6 >>> sunxi: change GIC address on H6 >>> sunxi: add clock code for H6 >>> sunxi: use sun6i-style watchdog for H6 >>> sunxi: add UART0 setup for H6 >>> sunxi: add MMC support for H6 >>> sunxi: add DRAM support to H6 >>> sunxi: add support for Allwinner H6 SoC >>> sunxi: add support for Pine H64 board
Reviewed-by: Jagan Teki <ja...@openedev.com> >> >>Observing SPL hang during relocation switch to board_init_r with >>orangepi board[1], will pine boot? look like both seem similar LPDDR3 >>configs atleast from schematics. > > Use v2.1 DRAM patch. Thanks. Tested-by: Jagan Teki <ja...@openedev.com> _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
