On Wed, Jul 25, 2018 at 5:23 AM Marek Vasut <ma...@denx.de> wrote: > > On 07/24/2018 09:25 PM, Adam Ford wrote: > > I am trying to boot an i.MX6Q via SPL to U-Boot and eventually, use > > Falcon mode to start the kernel. I can boot via SPL over USB. I have > > enabled the NAND and SPL NAND, and i can confirm that mxs_nand_spl.c > > is being built in. The board is imx6q_logic > > > > Unfortunately, I have run into two issues. > > > > 1. Imxs_nand_init from mxs_nand_spl.c is trying to run > > nand_chip.scan_bbt(mtd), but nand_chip.scan_bbt hasn't been defined > > from what i can tell. > > > > There is a function called nand_default_bb which looks like it should > > be setup as the default for this, but I am not sure. As-is, the > > system crashes when it attempts to run because it's a broken/NULL > > function pointer. Is there something that should initialize this > > pointer and/or what should it reference? > > > > 2. With the #1 commented out, I get some error messages, but I am > > mostly concerned about the BCH read timeout. I am asking if there is > > something missing. > > > > #define CONFIG_SYS_NAND_U_BOOT_OFFS 0x200000 > > +CC Stefano. > > btw I think you need kobs-ng to write the SPL in the special NXP format.
I did that. It wouldn't have booted at all without it. > > -- > Best regards, > Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
