On 11/06/2018 14:26, Baruch Siach wrote: > The newer rev 1.5 of the SolidRun i.MX6 SOM can optionally come with eMMC on > the SOM. This series adds support for the eMMC device on these SOMs. > > Since eMMC has card detect signal this series uses the new mmc_get_op_cond() > function that is broken out of mmc_init_start(). Successful completion of > mmc_get_op_cond() indicates that the eMMC is present. > > Finally, the last patch in this series constructs the name of the kernel > device tree to load. This name is compatible with recent mainline kernels. > > This series depends on the patches adding support for SOM rev 1.5 that were > posted earlier: > > https://patchwork.ozlabs.org/patch/926302/ > https://patchwork.ozlabs.org/patch/926301/ > > Baruch Siach (2): > mmc: drop mention of IN_PROGRESS status > mx6cuboxi: drop CONFIG_SYS_FSL_USDHC_NUM > > Jon Nettleton (4): > mmc: break out get_op_cond code to its own function > mx6cuboxi: Add support for eMMC booting > mx6cuboxi: Use mmc_get_op_cond() to check for an eMMC > mx6cuboxi: Add emmc device tree suffix > > board/solidrun/mx6cuboxi/mx6cuboxi.c | 115 +++++++++++++++++++++++++-- > drivers/mmc/mmc.c | 61 ++++++++------ > include/configs/mx6cuboxi.h | 25 +++--- > include/mmc.h | 12 ++- > 4 files changed, 167 insertions(+), 46 deletions(-) >
Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
