This commit adds a content section and also instructions on how to create a bootable SD/MMC device for RK3399 boards.
Signed-off-by: Ezequiel Garcia <ezequ...@collabora.com> --- board/rockchip/evb_rk3399/README | 55 ++++++++++++++++++++++++++++++-- 1 file changed, 53 insertions(+), 2 deletions(-) diff --git a/board/rockchip/evb_rk3399/README b/board/rockchip/evb_rk3399/README index 0b4c6d19ad39..3775d3ff447f 100644 --- a/board/rockchip/evb_rk3399/README +++ b/board/rockchip/evb_rk3399/README @@ -1,3 +1,21 @@ +Contents +======== + +1. Introduction +2. Get the Source and prebuild binary +3. Compile the ATF +4. Compile the U-Boot +5. Compile the rkdeveloptool +6. Package the image + 6.1. Package the image for U-Boot SPL(option 1) + 6.2. Package the image for Rockchip miniloader(option 2) +7. Bootloader storage options +8. Flash the image to eMMC + 8.1. Flash the image with U-Boot SPL(option 1) + 8.2. Flash the image with Rockchip miniloader(option 2) +9. Create a bootable SD/MMC +10. And that is it + Introduction ============ @@ -97,6 +115,12 @@ Package the image for Rockchip miniloader(option 2) Get trust.img and uboot.img in this step. +Bootloader storage options +========================== + +There are a few different storage options for the bootloader. +This document explores two of these: eMMC and removable SD/MMC. + Flash the image to eMMC ======================= @@ -117,6 +141,33 @@ Power on(or reset with RESET KEY) with MASKROM KEY preesed, and then: > rkdeveloptool wl 0x6000 u-boot/trust.img > rkdeveloptool rd +Create a bootable SD/MMC +======================== + +The idbspl.img contains the first stage, and the u-boot.img the second stage. +As explained in the Rockchip partition table reference [2], the first stage +(aka loader1) start sector is 64, and the second stage start sector is 16384. + +Each sector is 512 bytes, which means the first stage offset is 32 KiB, +and the second stage offset is 8 MiB. + +Note: the second stage location is actually not as per the spec, +but defined by the SPL. Mainline SPL defines an 8 MiB offset for the second +stage. + +Assuming the SD card is exposed by device /dev/mmcblk0, the commands +to write the two stages are: + + > dd if=idbspl.img of=/dev/mmcblk0 bs=1k seek=32 + > dd if=u-boot.itb of=/dev/mmcblk0 bs=1k seek=8192 + +Setting up the kernel and rootfs is beyond the scope of this document. + +And that is it +============== + You should be able to get U-Boot log in console/UART2(baurdrate 1500000) -For more detail, please reference to: -http://opensource.rock-chips.com/wiki_Boot_option +For more detail, please reference [2]. + +[1] http://opensource.rock-chips.com/wiki_Partitions +[2] http://opensource.rock-chips.com/wiki_Boot_option -- 2.18.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
