On 06/20/2018 12:03 AM, Simon Glass wrote: > Hi Heinrich, > > On 14 June 2018 at 23:01, Heinrich Schuchardt <xypron.g...@gmx.de> wrote: >> Typically init_scsi() does not output anything. So initr_scsi() should >> provide a \n or we may see borked output like >> >> SCSI: Net: No ethernet found. >> >> as observed with sandbox_defconfig. >> >> Signed-off-by: Heinrich Schuchardt <xypron.g...@gmx.de> >> --- >> common/board_r.c | 1 + >> 1 file changed, 1 insertion(+) > > Instead of this, we should enable DM_SCSI on sandbox. > > Regards, > Simon > The function initr_scsi() is built for #if defined(CONFIG_SCSI) && !defined(CONFIG_DM_SCSI)
Once all boards that support CONFIG_SCSI can be configured with CONFIG_DM_SCSI we should remove the symbol CONFIG_SCSI and function initr_scsi(). But we have not even enabled BLK for all supported boards. BLK is required for DM_SCSI. Till then problem I observed will be reproducible on other architectures than sandbox if no SCSI disk is attached. Best regards Heinrich _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
