Prafulla Wadaskar wrote: > This patch fixes following build warning > > Invalid Kwbimage command Type - valid names are: BOOT_FROM, NAND_ECC_MODE, > NAND_PAGE_SIZE, SATA_PIO_MODE, DDR_INIT_DELAY, DATA, , spi, nand, sata, pex, > uart > > Signed-off-by: Prafulla Wadaskar <prafu...@marvell.com> > --- > board/keymile/km_arm/kwbimage.cfg | 3 +-- > 1 files changed, 1 insertions(+), 2 deletions(-) > > diff --git a/board/keymile/km_arm/kwbimage.cfg > b/board/keymile/km_arm/kwbimage.cfg > index d6edd27..26d6aa0 100644 > --- a/board/keymile/km_arm/kwbimage.cfg > +++ b/board/keymile/km_arm/kwbimage.cfg > @@ -64,7 +64,6 @@ DATA 0xFFD01400 0x43000400 # SDRAM Configuration Register > # bit31-30: 01 > > DATA 0xFFD01404 0x36343000 # DDR Controller Control Low > - 0x38543000 > # bit 3-0: 0 reserved > # bit 4: 0=addr/cmd in smame cycle > # bit 5: 0=clk is driven during self refresh, we don't care for APX > @@ -170,7 +169,7 @@ DATA 0xFFD0149C 0x0000E90F # CPU ODT Control > # bit11-10:2, DQ_ODTSel. ODT select turned on, 75 ohm > > DATA 0xFFD01480 0x00000001 # DDR Initialization Control > -#bit0=1, enable DDR init upon this register write > +# bit0=1, enable DDR init upon this register write > > # End of Header extension > DATA 0x0 0x0 This patch did not fix any of the warnings I saw. Please recheck. Tom
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
