Dinh, A while ago, you posted the following patchset for SoCFPGA to add the PL330 DMA driver, and updated the SoCFPGA SDRAM init to write zeros to SDRAM to initialize the ECC bits if ECC was enabled:
https://lists.denx.de/pipermail/u-boot/2016-October/269643.html I know it's been a long time, so I'll summarize some of the conversation... At the time, you had a problem with the patchset causing the SPL to fail to find the MMC. You had tracked it down to an issue with the following commit "a78cd8613204 ARM: Rework and correct barrier definitions". You and Marek discussed it a bit, but I don't think there was a real conclusion. You submitted a second version of the patchset asking for advice on debugging the issue: https://lists.denx.de/pipermail/u-boot/2016-December/275822.html No real conversation came from the second patchset, and that was the end of the patch. I was hoping we could revisit adding your patchset again. I am working on a custom SoCFPGA board with a Cyclone V and ECC SDRAM. I rebased your patchset against v2018.05 and it is working on my custom board (although I don't have an MMC). I also tested it on a SoCKit booting from an MMC (I forced it to scrub the SDRAM on the SoCKit, because it doesn't have ECC RAM), and the SoCKit finds the MMC and boots. I don't have any suggestions on why it is working now on my board and not back when you first submitted the patchset. Maybe something else was fixed in the MMC? I was hoping you and Marek could test this patch again on some different SoCFPGA boards to see if you get the same results. Regards, Jason _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
