Hi Jagan,
On Wed, Jun 27, 2018 at 12:08:26PM +0530, Jagan Teki wrote:
> On Tue, Jun 26, 2018 at 10:28 PM, Angelo Dureghello <ang...@sysam.it> wrote:
> > This patch adds DM support to cf_spi.c.
> >
> > How to use/test it:
> >
> > 1) enable the following options,
> >
> > CONFIG_DM_SPI
> > CONFIG_DM_SPI_FLASH
> >
> > 2) add similar code into your board.c file
> >
> > U_BOOT_DEVICE(coldfire_spi) = {
> > .name = "spi_coldfire",
> > .platdata = &mcf_spi_plat,
> > };
> >
> > ---
> > Changes from v1:
> > - split into 2 patches
> >
> > Changes from v2:
> > - back in a single patch, no need to add fdt support or special
> > config options
> > - doc/driver-model/spi-howto.txt has been re-checked and followed,
> > the driver now builds as is.
>
> Nice, How about full dm conversion. I have seen few boards using this
> driver and its quite manageble for full switching. what do you think?
Sorry, what do you mean exactly for full switching ?
My understanding is, to remove the non-dm part of the driver and add to
each board proper device struct and config options, correct ?
In this case, i can only test it on my stmark2 board, but i think could
be enough.
Regards,
Angelo
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
