> -----Original Message----- > From: Heiko Schocher [mailto:h...@denx.de] > Sent: Friday, February 12, 2010 1:36 PM > To: U-Boot user list > Cc: Wolfgang Denk; Prafulla Wadaskar; Scott Wood; Stefan Roese > Subject: [PATCH 2/4 v4] arm: add support for the suen3 board > from keymile > > This patch adds support for the Keymile suen3 board which > is based on the Marvell Kirkwood (88F6281) SoC. As this > is a variant of the mgcoge2_arm_p1a board, this board > also uses common code stored in board/keymile/km_arm/km_arm.c > > Signed-off-by: Heiko Schocher <h...@denx.de> > --- > - changes since v1: > added comments from Wolfgang Denk: > get rid of flash_info_t define in board config > (to get this working patch 1/2 is introduced/needed) > > - changes since v2: > added comments from Wolfgang Denk > - rearranged if/else in do_spi_toggle() > - added I/O accessor functions for bootcounter > > - changes since v3: > added comment Scott Wood > - removed nand_init in do_spi_toggle() > > added comments from Prafulla Wadagaskar > - km-arm.h renamed to km_arm.h > - reworked eeprom_write_enable() (deleted it) > (when reviewing this function, it cropped up, that > this pin is connected through a gpio pin, not as > in previous version, through the boco (a FPGA)) > - moved set_sda(), set_scl(), get_sda(), get_scl() > to km_arm.c > - split patch in 4 patches (for each board an extra patch) > - renamed sdramregs.txt in kwbimage.cfg, also license > info added. > > MAINTAINERS | 1 + > MAKEALL | 1 + > Makefile | 3 + > include/configs/suen3.h | 103
There is some code in earlier patch (i.e 1/4) for this board support that should reflect here. This gives better understanding Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
