Add code to reset all reset signals as in serial DT node. A reset property is
an optional feature,
so do not fail if a reset property is not present.
If a reset property is discovered, then use it to deassert, thus bringing the
IP out of reset.
Signed-off-by: Ley Foon Tan <ley.foon....@intel.com>
Reviewed-by: Marek Vasut <ma...@denx.de>
---
drivers/serial/ns16550.c | 8 ++++++++
1 files changed, 8 insertions(+), 0 deletions(-)
diff --git a/drivers/serial/ns16550.c b/drivers/serial/ns16550.c
index 53550bf..9c80090 100644
--- a/drivers/serial/ns16550.c
+++ b/drivers/serial/ns16550.c
@@ -9,6 +9,7 @@
#include <dm.h>
#include <errno.h>
#include <ns16550.h>
+#include <reset.h>
#include <serial.h>
#include <watchdog.h>
#include <linux/types.h>
@@ -177,6 +178,7 @@ void NS16550_init(NS16550_t com_port, int baud_divisor)
#if defined(CONFIG_ARCH_OMAP2PLUS)
serial_out(0x7, &com_port->mdr1); /* mode select reset TL16C750*/
#endif
+
serial_out(UART_MCRVAL, &com_port->mcr);
serial_out(ns16550_getfcr(com_port), &com_port->fcr);
if (baud_divisor != -1)
@@ -370,6 +372,12 @@ static int ns16550_serial_setbrg(struct udevice *dev, int
baudrate)
int ns16550_serial_probe(struct udevice *dev)
{
struct NS16550 *const com_port = dev_get_priv(dev);
+ struct reset_ctl_bulk reset_bulk;
+ int ret;
+
+ ret = reset_get_bulk(dev, &reset_bulk);
+ if (!ret)
+ reset_deassert_bulk(&reset_bulk);
com_port->plat = dev_get_platdata(dev);
NS16550_init(com_port, -1);
--
1.7.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
