Hi Guillaume,
On Thu, Apr 12, 2018 at 02:48:07PM +0200, Guillaume Gardet wrote:
>
>
> Le 12/04/2018 à 14:36, Gary Bisson a écrit :
> > Hi Fabio, Guillaume
> >
> > On Thu, Apr 12, 2018 at 08:14:51AM -0300, Fabio Estevam wrote:
> > > On Thu, Apr 12, 2018 at 5:13 AM, Guillaume Gardet
> > > <guillaume.gar...@free.fr> wrote:
> > > script that picks the correct dtb.
> > > > Ok. So, how would you like to proceed?
> > > > Remove the generic mx6 'soc' definition and use a board sepcific
> > > > 'board_rev'
> > > > (or maybe a static definition if one configuration match a single dtb)
> > > > to
> > > > define the right dtb?
> > > I prefer to keep the same solution as done in other boards sucn as
> > > mx6sabresd, wandboard and cuboxi.
> > Ok. My suggestion was to have something generic so that it matches the
> > fdt name set in config_distro_bootcmd.h
> > (${soc}-${board}${boardver}.dtb).
> >
> > I especially like the naming in that standard, don't think board_rev
> > should be the SOC name.
> >
> > This would also avoid redundancy in each board_late_init functions since
> > only the board name would need to be setup (and boardver in some cases
> > like wandboard).
> >
> > Guillaume, please forget that point for now and just set your fdtfile
> > name in the config file. I'll update the board file later on.
>
> Ok.
>
> Could you just confirm which DTB should work with the various nitrogen6x
> boards config, please?
> Are the following ok?
> * imx6q-nitrogen6x.dts => nitrogen6q2g_defconfig nitrogen6q_defconfig
> * imx6dl-nitrogen6x.dts => nitrogen6dl2g_defconfig
> nitrogen6dl_defconfig
> * imx6sx-nitrogen6sx.dts => nitrogen6s1g_defconfig
> nitrogen6s_defconfig
No, imx6sx is different than imx6s. Solo is the same as imx6dl as far as
the kernl is concerned.
Maybe just leave fdt_file blank for nitrogen6x for now, it's only necessary
for PXE which isn't enabled in nitrogen6*defconfig.
Regards,
Gary
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
