The function get_osc_clk_speed() is used to determine the master
clock. If SYS_CLK is being divided by 2, the divider is changed
to 1 - without following any sequence.
Before reaching this function, some of the clocks have already
been set (by x-loader or equiv) OR power-on defaults are in use.
This change is too sudden, leading to instability beyond certain
tolerance zone.
The problem was observed with DM3730 (silimar to OMAP3630), on
the OMAP3EVM.
This patch removes the step to change clock divider. Instead,
uses a multiplication factor (if needed). Mathematically, the
formula is unchanged.
Tested on OMAP3EVM with OMAP3530 and DM3730.
Signed-off-by: Sanjeev Premi <pr...@ti.com>
Signed-off-by: Hiremath Vaibhav <hvaib...@ti.com>
---
cpu/arm_cortexa8/omap3/clock.c | 15 +++++++++++----
1 files changed, 11 insertions(+), 4 deletions(-)
diff --git a/cpu/arm_cortexa8/omap3/clock.c b/cpu/arm_cortexa8/omap3/clock.c
index 174c453..e8189b4 100644
--- a/cpu/arm_cortexa8/omap3/clock.c
+++ b/cpu/arm_cortexa8/omap3/clock.c
@@ -40,7 +40,7 @@
*****************************************************************************/
u32 get_osc_clk_speed(void)
{
- u32 start, cstart, cend, cdiff, val;
+ u32 start, cstart, cend, cdiff, cdiv, val;
struct prcm *prcm_base = (struct prcm *)PRCM_BASE;
struct prm *prm_base = (struct prm *)PRM_BASE;
struct gptimer *gpt1_base = (struct gptimer *)OMAP34XX_GPT1;
@@ -48,9 +48,13 @@ u32 get_osc_clk_speed(void)
val = readl(&prm_base->clksrc_ctrl);
- /* If SYS_CLK is being divided by 2, remove for now */
- val = (val & (~SYSCLKDIV_2)) | SYSCLKDIV_1;
- writel(val, &prm_base->clksrc_ctrl);
+ if (val & SYSCLKDIV_2)
+ cdiv = 2;
+ else if (val & SYSCLKDIV_1)
+ cdiv = 1;
+ else
+ /*Should never reach here! (Assume divider as 1) */
+ cdiv = 1;
/* enable timer2 */
val = readl(&prcm_base->clksel_wkup) | CLKSEL_GPT1;
@@ -83,6 +87,9 @@ u32 get_osc_clk_speed(void)
cend = readl(&gpt1_base->tcrr); /* get end sys_clk count */
cdiff = cend - cstart; /* get elapsed ticks */
+ if (cdiv == 2)
+ cdiff *= 2;
+
/* based on number of ticks assign speed */
if (cdiff > 19000)
return S38_4M;
--
1.6.2.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
