Dear Alessandro Rubini, In message <20100126081343.ga7...@morgana.gnudd.com> you wrote: > > > 4940 11/25 Alessandro Rubini [U-Boot] [PATCH V4] Nomadik: fix > > reset_timer() > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72083 > > This is needed for saveenv to work reliably. I'd like it to be merged
Me too. Tom? > > 5260 12/05 Alessandro Rubini [U-Boot] [PATCH V3 1/9] nhk8815: change the > > order of initialization > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72396 > > Needed for correct bringup of diplay in 7/9 and 9/9. > > > 5261 12/05 Alessandro Rubini [U-Boot] [PATCH V3 2/9] video: add > > amba-clcd prime-cell > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72397 > > 5262 12/05 Alessandro Rubini [U-Boot] [PATCH V3 3/9] include/nomadik.h: > > add physical address for cldc > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72398 > > These two have been applied to u-boot-video/next by Anatolij (Dec 12). Still > in next branch. OK. As long as I haven't pulled, they will remain open for me. > > 5263 12/05 Alessandro Rubini [U-Boot] [PATCH V3 4/9] drivers/misc: add > > stmpe2401 port extender and keypad controller > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72399 > > 5264 12/05 Alessandro Rubini [U-Boot] [PATCH V3 5/9] nhk8815.h: define > > we need stmpe > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72400 > > 5265 12/05 Alessandro Rubini [U-Boot] [PATCH V3 6/9] lcd: make 16bpp work > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72401 > > 5266 12/05 Alessandro Rubini [U-Boot] [PATCH V3 7/9] nhk8815: added > > keypad > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72402 > > 5267 12/05 Alessandro Rubini [U-Boot] [PATCH V3 8/9] nhk8815: start > > lower in RAM, so the 800x480 frame buffer fits > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72403 > > 5268 12/05 Alessandro Rubini [U-Boot] [PATCH V3 9/9] nhk8815: added lcd > > support > > http://article.gmane.org/gmane.comp.boot-loaders.u-boot/72404 > > These depend on the ones in video/next and apply cleanly to the > master branch as of today. There is one minor delay about > lcd_setfgcolor/lcd_setbgcolor that was sorted out by Anatolij on Dec > 12 ("lcd: remove CONFIG_ATMEL_LCD ifdefs from lcd_setfgcolor"). > But his patch isn't in master yet nor in the video branches. OK, so this is all work for Anatolij and Tom. Thanks a lot for the review & summary. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de If you fail to plan, plan to fail. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
