On 16.2.2018 15:14, Vipul Kumar wrote:
> This patch added Kconfig support for CONFIG_SYS_ZYNQ_QSPI_WAIT
> and set it to default value 10 milliseconds.
>
> Signed-off-by: Vipul Kumar <vip...@xilinx.com>
> Signed-off-by: Siva Durga Prasad Paladugu <siva...@xilinx.com>
> ---
> drivers/spi/Kconfig | 6 ++++++
> drivers/spi/zynq_qspi.c | 3 ---
> 2 files changed, 6 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
> index 235a8c7..436e9ad 100644
> --- a/drivers/spi/Kconfig
> +++ b/drivers/spi/Kconfig
> @@ -204,6 +204,12 @@ config ZYNQ_QSPI
> Zynq QSPI IP core. This IP is used to connect the flash in
> 4-bit qspi, 8-bit dual stacked and shared 4-bit dual parallel.
>
> +config SYS_ZYNQ_QSPI_WAIT
> + int "Define Zynq QSPI wait time in ms"
here I am missing depends on ZYNQ_QSPI.
M
> + default 10
> + help
> + Define default Zynq QSPI wait time in milliseconds.
> +
> endif # if DM_SPI
>
> config SOFT_SPI
> diff --git a/drivers/spi/zynq_qspi.c b/drivers/spi/zynq_qspi.c
> index 255e02f..c9241aa 100644
> --- a/drivers/spi/zynq_qspi.c
> +++ b/drivers/spi/zynq_qspi.c
> @@ -46,9 +46,6 @@ DECLARE_GLOBAL_DATA_PTR;
> #define ZYNQ_QSPI_CR_SS_SHIFT 10 /* Slave select shift */
>
> #define ZYNQ_QSPI_FIFO_DEPTH 63
> -#ifndef CONFIG_SYS_ZYNQ_QSPI_WAIT
> -#define CONFIG_SYS_ZYNQ_QSPI_WAIT CONFIG_SYS_HZ/100 /* 10 ms */
> -#endif
>
> /* zynq qspi register set */
> struct zynq_qspi_regs {
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
