To avoid clutter in the NAND menu, let's make the NAND controllers
dependent on which ARCH type uses them. This way, we cannot
accidentally try to enable a NAND controller that doesn't exist.
This is based on Convert CONFIG_SYS_MAX_NAND_DEVICE to Kconfig and
add CONFIG_NAND that was just submitted.
Signed-off-by: Adam Ford <aford...@gmail.com>
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index e991440..96c118f 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -9,6 +9,7 @@ config SYS_NAND_SELF_INIT
This option, if enabled, provides more flexible and linux-like
NAND initialization process.
+if ARCH_UNIPHIER
config NAND_DENALI
bool
select SYS_NAND_SELF_INIT
@@ -31,6 +32,8 @@ config NAND_DENALI_SPARE_AREA_SKIP_BYTES
of OOB area before last ECC sector data starts. This is potentially
used to preserve the bad block marker in the OOB area.
+endif
+
config NAND_OMAP_GPMC
bool "Support OMAP GPMC NAND controller"
depends on ARCH_OMAP2PLUS
@@ -87,6 +90,7 @@ endchoice
config NAND_PXA3XX
bool "Support for NAND on PXA3xx and Armada 370/XP/38x"
+ depends on ARCH_MVEBU
select SYS_NAND_SELF_INIT
imply CMD_NAND
help
@@ -123,6 +127,7 @@ endif
config NAND_ARASAN
bool "Configure Arasan Nand"
+ depends on ARCH_ZYNQMP
imply CMD_NAND
help
This enables Nand driver support for Arasan nand flash
@@ -147,6 +152,7 @@ config NAND_MXS
config NAND_ZYNQ
bool "Support for Zynq Nand controller"
+ depends on ARCH_ZYNQ
select SYS_NAND_SELF_INIT
imply CMD_NAND
help
@@ -226,6 +232,7 @@ config SPL_NAND_AM33XX_BCH
config SPL_NAND_DENALI
bool "Support Denali NAND controller for SPL"
+ depends on ARCH_UNIPHIER
help
This is a small implementation of the Denali NAND controller
for use on SPL.
--
2.7.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
