Pull out the GIC macros from the board configuration files into the common Gen3 configuration file since these macros are the same for all Gen3 systems.
Signed-off-by: Marek Vasut <marek.vasut+rene...@gmail.com> Cc: Nobuhiro Iwamatsu <iwama...@nigauri.org> --- include/configs/rcar-gen3-common.h | 5 +++++ include/configs/salvator-x.h | 5 ----- include/configs/ulcb.h | 5 ----- 3 files changed, 5 insertions(+), 10 deletions(-) diff --git a/include/configs/rcar-gen3-common.h b/include/configs/rcar-gen3-common.h index 6deed0dcd7..dd6863e64e 100644 --- a/include/configs/rcar-gen3-common.h +++ b/include/configs/rcar-gen3-common.h @@ -31,6 +31,11 @@ #define CONFIG_ARCH_CPU_INIT +/* Generic Interrupt Controller Definitions */ +#define CONFIG_GICV2 +#define GICD_BASE 0xF1010000 +#define GICC_BASE 0xF1020000 + /* console */ #define CONFIG_SYS_CBSIZE 2048 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE diff --git a/include/configs/salvator-x.h b/include/configs/salvator-x.h index 8616b36ecc..5004fa31b6 100644 --- a/include/configs/salvator-x.h +++ b/include/configs/salvator-x.h @@ -42,11 +42,6 @@ /* Generic Timer Definitions (use in assembler source) */ #define COUNTER_FREQUENCY 0xFE502A /* 16.66MHz from CPclk */ -/* Generic Interrupt Controller Definitions */ -#define CONFIG_GICV2 -#define GICD_BASE 0xF1010000 -#define GICC_BASE 0xF1020000 - /* i2c */ #define CONFIG_SYS_I2C #define CONFIG_SYS_I2C_SH diff --git a/include/configs/ulcb.h b/include/configs/ulcb.h index a4795c5ff3..41ba5972a6 100644 --- a/include/configs/ulcb.h +++ b/include/configs/ulcb.h @@ -50,11 +50,6 @@ /* Generic Timer Definitions (use in assembler source) */ #define COUNTER_FREQUENCY 0xFE502A /* 16.66MHz from CPclk */ -/* Generic Interrupt Controller Definitions */ -#define CONFIG_GICV2 -#define GICD_BASE 0xF1010000 -#define GICC_BASE 0xF1020000 - /* CPLD SPI */ #define CONFIG_CMD_SPI #define CONFIG_SOFT_SPI -- 2.15.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
