> -----Original Message----- > From: Andrew Lunn [mailto:and...@lunn.ch] > Sent: Tuesday, November 28, 2017 4:13 PM > To: Madalin-cristian Bucur <madalin.bu...@nxp.com> > Subject: Re: [RFC] Support for SGMII 2500 > > > Hi Andrew, > > > > Bhaskar is working on enabling a PFE [1] MAC connected to an Aquantia > AQR107 > > PHY [2] on a LS1012AQDS board. Initially I've indicated 2500Base-X too, > but it > > seems the HW actually works in SGMII mode. The QDS boards are lower > volume, > > higher spec boards than the RDBs [3], they exercise most of the HW > capabilities. > > The webpage for the AQR107 lists 2500Base-X, so i assume the issue is > with the MAC? Ideally you want to use 2500Base-X, since this is wider > known. > > Anyway, you seem to have a legitimate need for it. > > However, i would prefer a different name. The convention is to put the > number first. So PHY_INTERFACE_MODE_2500SGMII. > > Andrew
OK, I just wanted to make sure 2.5G SGMII is to be added separately from the "normal" SGMII, as it was done in u-boot. Thanks also for the naming hint. Madalin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
