The XIRQ pins are now set up on the Linux side by the GPIO hogging.
Signed-off-by: Masahiro Yamada <yamada.masah...@socionext.com>
---
arch/arm/mach-uniphier/board_init.c | 16 ----------------
1 file changed, 16 deletions(-)
diff --git a/arch/arm/mach-uniphier/board_init.c
b/arch/arm/mach-uniphier/board_init.c
index 28784ea..121b786 100644
--- a/arch/arm/mach-uniphier/board_init.c
+++ b/arch/arm/mach-uniphier/board_init.c
@@ -17,24 +17,9 @@
DECLARE_GLOBAL_DATA_PTR;
-#ifdef CONFIG_ARCH_UNIPHIER_LD11
-static void uniphier_ld11_misc_init(void)
-{
- sg_set_pinsel(149, 14, 8, 4); /* XIRQ0 -> XIRQ0 */
- sg_set_iectrl(149);
- sg_set_pinsel(153, 14, 8, 4); /* XIRQ4 -> XIRQ4 */
- sg_set_iectrl(153);
-}
-#endif
-
#ifdef CONFIG_ARCH_UNIPHIER_LD20
static void uniphier_ld20_misc_init(void)
{
- sg_set_pinsel(149, 14, 8, 4); /* XIRQ0 -> XIRQ0 */
- sg_set_iectrl(149);
- sg_set_pinsel(153, 14, 8, 4); /* XIRQ4 -> XIRQ4 */
- sg_set_iectrl(153);
-
/* ES1 errata: increase VDD09 supply to suppress VBO noise */
if (uniphier_get_soc_revision() == 1) {
writel(0x00000003, 0x6184e004);
@@ -105,7 +90,6 @@ static const struct uniphier_initdata uniphier_initdata[] = {
.sbc_init = uniphier_ld11_sbc_init,
.pll_init = uniphier_ld11_pll_init,
.clk_init = uniphier_ld11_clk_init,
- .misc_init = uniphier_ld11_misc_init,
},
#endif
#if defined(CONFIG_ARCH_UNIPHIER_LD20)
--
2.7.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
