[U-Boot] [PATCH 4/6] mx6cuboxi: Avoid calling setup_display() from SPL code

[Fabio Estevam]

From: Fabio Estevam <fabio.este...@nxp.com>

There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.

Reported-by: Stefano Babic <sba...@denx.de>
Signed-off-by: Fabio Estevam <fabio.este...@nxp.com>
---
 board/solidrun/mx6cuboxi/mx6cuboxi.c | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/board/solidrun/mx6cuboxi/mx6cuboxi.c 
b/board/solidrun/mx6cuboxi/mx6cuboxi.c
index 1e4da4a..ee9e4f7 100644
--- a/board/solidrun/mx6cuboxi/mx6cuboxi.c
+++ b/board/solidrun/mx6cuboxi/mx6cuboxi.c
@@ -308,13 +308,8 @@ int board_ehci_hcd_init(int port)
 
 int board_early_init_f(void)
 {
-       int ret = 0;
        setup_iomux_uart();
 
-#ifdef CONFIG_VIDEO_IPUV3
-       ret = setup_display();
-#endif
-
 #ifdef CONFIG_CMD_SATA
        setup_sata();
 #endif
@@ -322,15 +317,21 @@ int board_early_init_f(void)
 #ifdef CONFIG_USB_EHCI_MX6
        setup_usb();
 #endif
-       return ret;
+       return 0;
 }
 
 int board_init(void)
 {
+       int ret = 0;
+
        /* address of boot parameters */
        gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
 
-       return 0;
+#ifdef CONFIG_VIDEO_IPUV3
+       ret = setup_display();
+#endif
+
+       return ret;
 }
 
 static bool is_hummingboard(void)
-- 
2.7.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot