[U-Boot] [PATCH 07/10] rockchip: puma-rk3399: update board_init()

[Philipp Tomsich]

The original initialisation code for board_init() was largely lifted
from the code on the EVB.  However, the RK3399-Q7 can do with a much
more concise init sequence.

This cleans up the board_init() by updating it to the essentials for
the RK3399-Q7 and getting rid of the accumulated cruft.

Signed-off-by: Philipp Tomsich <philipp.toms...@theobroma-systems.com>
---

 board/theobroma-systems/puma_rk3399/puma-rk3399.c | 36 +++--------------------
 1 file changed, 4 insertions(+), 32 deletions(-)

diff --git a/board/theobroma-systems/puma_rk3399/puma-rk3399.c 
b/board/theobroma-systems/puma_rk3399/puma-rk3399.c
index 01b90e3..cc572b5 100644
--- a/board/theobroma-systems/puma_rk3399/puma-rk3399.c
+++ b/board/theobroma-systems/puma_rk3399/puma-rk3399.c
@@ -19,44 +19,16 @@ DECLARE_GLOBAL_DATA_PTR;
 
 int board_init(void)
 {
-       struct udevice *pinctrl, *regulator;
        int ret;
 
        /*
-        * The PWM does not have decicated interrupt number in dts and can
-        * not get periph_id by pinctrl framework, so let's init them here.
-        * The PWM2 and PWM3 are for pwm regulators.
+        * We need to call into regulators_enable_boot_on() again, as the call
+        * during SPL may have not included all regulators.
         */
-       ret = uclass_get_device(UCLASS_PINCTRL, 0, &pinctrl);
-       if (ret) {
-               debug("%s: Cannot find pinctrl device\n", __func__);
-               goto out;
-       }
-
-       ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_PWM2);
-       if (ret) {
-               debug("%s PWM2 pinctrl init fail!\n", __func__);
-               goto out;
-       }
-
-       /* rk3399 need to init vdd_center to get the correct output voltage */
-       ret = regulator_get_by_platname("vdd_center", &regulator);
+       ret = regulators_enable_boot_on(false);
        if (ret)
-               debug("%s: Cannot get vdd_center regulator\n", __func__);
-
-       ret = regulator_get_by_platname("vcc5v0_host", &regulator);
-       if (ret) {
-               debug("%s vcc5v0_host init fail! ret %d\n", __func__, ret);
-               goto out;
-       }
-
-       ret = regulator_set_enable(regulator, true);
-       if (ret) {
-               debug("%s vcc5v0-host-en set fail!\n", __func__);
-               goto out;
-       }
+               debug("%s: Cannot enable boot on regulator\n", __func__);
 
-out:
        return 0;
 }
 
-- 
2.1.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot