On 8/31/2017 4:13 PM, Troy Kisky wrote: > On 8/31/2017 4:04 PM, Eric Nelson wrote: >> On 08/31/2017 03:53 PM, Troy Kisky wrote: >>> On 8/31/2017 2:28 PM, Troy Kisky wrote: >>> >>>> >>>> Maybe if you change the WDOG pinmux it might work ? >>>> >>>> >>> >>> Worked for me >>> >>> => mm.l 302c0000 >>> 302c0000: 00000003 ? 0 >>> 302c0004: 00000001 ? q >>> => bmod usb >>> resetting ... >>> >> >> Hmm... >> >> On SABRE-SD or Nitrogen7? >> > > Nitrogen7, > > It does show up in lsusb afterwards > Bus 003 Device 100: ID 15a2:0076 Freescale Semiconductor, Inc. > > But imx_usb gets errors afterwards > > == work item > filename /tftpboot/u-boot.nitrogen7 > load_size 0 bytes > load_addr 0x00000000 > dcd 1 > clear_dcd 0 > plug 1 > jump_mode 2 > jump_addr 0x00000000 > == end work item > loading DCD table @0x910000 > > <<<-564, 1024 bytes>>> > report 3 in err=-7, last_trans=0 c4 34 03 32 > report 4 in err=-7, last_trans=0 c4 34 03 32 > failed (status 0x320334c4) > ________________ > > > So, close but no cigar. >
FYI => mw.l 302c0000 0 => reset resetting ... ___________________ Also just hangs. So, it is not "bmode" specify. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
