On Wed, Aug 30, 2017 at 8:01 PM, Suresh Gupta <suresh.gu...@nxp.com> wrote: > > >> -----Original Message----- >> From: Jagan Teki [mailto:jagannadh.t...@gmail.com] >> Sent: Wednesday, August 30, 2017 7:54 PM >> To: Suresh Gupta <suresh.gu...@nxp.com> >> Cc: u-boot@lists.denx.de; York Sun <york....@nxp.com> >> Subject: Re: [PATCH v3] spi: fsl_qspi: Add controller busy check before new >> spi >> operation >> >> On Wed, Aug 30, 2017 at 2:00 PM, Suresh Gupta <suresh.gu...@nxp.com> >> wrote: >> > It is recommended to check either controller is free to take new spi >> > action. The IP_ACC and AHB_ACC bits indicates that the controller is >> > busy in IP or AHB mode respectively. >> > And the BUSY bit indicates that controller is currently busy handling >> > a transaction to an external flash device >> > >> > Signed-off-by: Suresh Gupta <suresh.gu...@nxp.com> >> > --- >> > Chnages in v3: >> > - replace printf to debug >> > - return whatever return from wait_for_bit, before it was -EBUSY >> > >> > Changes in v2: >> > >> > - Add wait_for_bit instead of while >> > - move the busy check code to fsl_qspi_claim_bus form qspi_xfer >> > >> > >> > drivers/spi/fsl_qspi.c | 28 +++++++++++++++++++++++++++- >> > drivers/spi/fsl_qspi.h | 4 ++++ >> > 2 files changed, 31 insertions(+), 1 deletion(-) >> > >> > diff --git a/drivers/spi/fsl_qspi.c b/drivers/spi/fsl_qspi.c index >> > 1dfa89a..8f0f29e 100644 >> > --- a/drivers/spi/fsl_qspi.c >> > +++ b/drivers/spi/fsl_qspi.c >> > @@ -14,6 +14,7 @@ >> > #include <dm.h> >> > #include <errno.h> >> > #include <watchdog.h> >> > +#include <wait_bit.h> >> > #include "fsl_qspi.h" >> > >> > DECLARE_GLOBAL_DATA_PTR; >> > @@ -991,7 +992,7 @@ static int fsl_qspi_probe(struct udevice *bus) >> > struct fsl_qspi_platdata *plat = dev_get_platdata(bus); >> > struct fsl_qspi_priv *priv = dev_get_priv(bus); >> > struct dm_spi_bus *dm_spi_bus; >> > - int i; >> > + int i, ret; >> > >> > dm_spi_bus = bus->uclass_priv; >> > >> > @@ -1011,6 +1012,18 @@ static int fsl_qspi_probe(struct udevice *bus) >> > priv->flash_num = plat->flash_num; >> > priv->num_chipselect = plat->num_chipselect; >> > >> > + /* make sure controller is not busy anywhere */ >> > + ret = wait_for_bit(__func__, &priv->regs->sr, >> > + QSPI_SR_BUSY_MASK | >> > + QSPI_SR_AHB_ACC_MASK | >> > + QSPI_SR_IP_ACC_MASK, >> > + false, 1000, false); >> >> 100ms not enough? > It should be, Will send new patch
It's fine, if you're OK I will change it while applying. thanks! -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
