> -----Original Message-----
> From: Wolfgang Denk [mailto:w...@denx.de]
> Sent: Tuesday, November 24, 2009 1:33 AM
> To: Paulraj, Sandeep
> Cc: Hiremath, Vaibhav; u-boot@lists.denx.de
> Subject: Re: [U-Boot] [PATCH 0/5] Introducing TI's New SoC/board
> AM3517EVM
> 
> Dear "Paulraj, Sandeep",
> 
> In message
> <0554bef07d437848af01b9c9b5f0bc5d942dc...@dlee01.ent.ti.com> you
> wrote:
> >
> > I hope you made the patches against the current u-boot-ti/master
> 
> Please note that this is a tendency I seriously dislike.
> 
> 
> Please do NOT do this.
> 
> 
> Please see bullet # 3 at http://www.denx.de/wiki/U-Boot/Patches :
> 
>       Please use the "master" branch of the mainline U-Boot git
>       repository (git://git.denx.de/u-boot.git) as reference, unless
>       (usually late in a release cycle) there has been an
>       announcement to use the "next" branch of this repository
>       instead.
> 
> If we see patches againt any of 30 or so custodian trees, which
> don't
> apply against the "official" master tree, we will see chaos pretty
> soon. Please let's make sure there is only minimal difference
> between
> custdian trees and "master" (or "next"), so there is no reason to
> use
> custodian tress as reference for patches instead.
> 
> 
> Please _always_ use "master" (or "next") as base for patches!
> 
[Hiremath, Vaibhav] Before submitting patch I conformed that the patches gets 
applied on master branch cleanly.

Thanks,
Vaibhav

> Best regards,
> 
> Wolfgang Denk
> 
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev
> Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell,
> Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email:
> w...@denx.de
> A Perl script is correct if it's halfway readable and  gets  the
> job
> done before your boss fires you.
>                        - L. Wall & R. L. Schwartz, _Programming
> Perl_
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to