Dear Ben,

In message <4acdde30.8030...@bus-elektronik.de> Jens Scharsig wrote:
> This patch adds a new net api driver for AT91RM9200 EMAC
> 
> * adds NET_MULTI api EMAC (CONFIG_DRIVER_AT91EMAC)
> * generic PHY initialization 
> 
> Signed-off-by: Jens Scharsig <e...@bus-elektronik.de>
> ---
> 
> This patch was tested with full MII interface and LXT971 Phy on our 
> upcomming new board.
> I have also tested the RMII interface with DM9161 Phy on a CARMEVA-board.
> 
> I have no u-boot supported AT91RM9200 boards. 
> 
> My appeal to all  AT91RM9200 boards maintainers: Please test
> 
> Changes to make your board use NET_MULTI api: 
> 
>   * include/configs/<board>.h
>     1. change CONFIG_DRIVER_ETHER to CONFIG_DRIVER_AT91EMAC
>     2. define CONFIG_NET_MULTI
>     3. set CONFIG_SYS_RX_ETH_BUFFER, if you want more than standard rx buffers
>     4. define CONFIG_AT91C_USE_RMII, if you board use RMII interface
> 
>   * add following code to board file
>     #ifdef CONFIG_DRIVER_AT91EMAC
>     int board_eth_init(bd_t *bis)
>     {
>           int rc = 0;
>           rc = at91emac_register(bis, AT91C_BASE_EMAC);
>           return rc;
>     }
>     #endif

Could you please check the status of this patch:
http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/69484

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Nobody trips over mountains. It is the small pebble that  causes  you
to  stumble.  Pass all the pebbles in your path and you will find you
have crossed the mountain.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to