Dear Albin Tonnerre,
In message
<1252442374-25386-1-git-send-email-albin.tonne...@free-electrons.com> you wrote:
> This patch allows to use the atmel_mci SD/MMC driver on the at91 architecture.
> It contains:
> - initialization code for the MCI controller for all the supported AT91. It
> allows the use of only one controller even if a SoC has two controllers
> (anyway there's no support for it in atmel_mci as of now)
> - the necessary get_mci_clk_rate function
> - definition of MMCI_BASE for use in atmel_mci
> - the cpu_mmc_init function. As of now this is not used, but will be required
> when atmel_mci is ported to the new generic mmc API.
>
> Signed-off-by: Albin Tonnerre <albin.tonne...@free-electrons.com>
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagn...@jcrosoft.com>
> ---
> Changes since v1
> - Fix the MCI controller ID in the init code for CAP9, SAM9263 and SAM9G45
> - Move AT91_BASE_MCI* define to soc header
> - define AT91_BASE_MCI{0,1} instead of AT91_BASE_MCI for boards which have 2
> controllers
> - rework the way MMCI_BASE is defined accordingly
>
> Changes since v2
> - allow using 8-bit bus width on CPUs that support it
> - change the arguments of atmel_mciX_hw_init to (slot, bus) so that it's more
> meaningful than (bitmask)
What's the current state of this patch? Do you consider it ripe for
inclusion into mainline, or do you still have changes pending?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Q: How many DEC repairman does it take to fix a flat?
A: Five; four to hold the car up and one to swap tires.
Q: How long does it take?
A: It's indeterminate. It will depend upon how many flats they've
brought with them.
Q: What happens if you've got TWO flats?
A: They replace your generator.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
