The order of parameters passed to the phy_connect() was wrong.
Moreover, only PHY address 0 was used. Replace this with code
capable of detecting the PHY address.
Signed-off-by: Marek Vasut <marek.vasut+rene...@gmail.com>
Cc: Joe Hershberger <joe.hershber...@ni.com>
Cc: Nobuhiro Iwamatsu <iwama...@nigauri.org>
---
drivers/net/ravb.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c
index 7f0e2568b7..ce0eacceb6 100644
--- a/drivers/net/ravb.c
+++ b/drivers/net/ravb.c
@@ -298,13 +298,14 @@ static int ravb_phy_config(struct udevice *dev)
struct ravb_priv *eth = dev_get_priv(dev);
struct eth_pdata *pdata = dev_get_platdata(dev);
struct phy_device *phydev;
- int reg;
+ int mask = 0xffffffff, reg;
- phydev = phy_connect(eth->bus, pdata->phy_interface,
- dev, PHY_INTERFACE_MODE_RGMII_ID);
+ phydev = phy_find_by_mask(eth->bus, mask, pdata->phy_interface);
if (!phydev)
return -ENODEV;
+ phy_connect_dev(phydev, dev);
+
eth->phydev = phydev;
/* 10BASE is not supported for Ethernet AVB MAC */
--
2.11.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
