Hi, I am using a Sabre Auto board with an i.MX6 Dual Lite.
When I compile U-boot with defconfig file mx6dlsabreauto_defconfig, the network is not functionnal. Only the orange LED on the RJ45 port is blinking and dhcp requests never end. In menuconfig I saw numerous unselected options that I guess should be enabled. But event with that, I could not get through: CONFIG_NET_RANDOM_ETHADDR=y CONFIG_PHYLIB=y CONFIG_NETDEVICES=y CONFIG_FEC_MXC=y The issue is present in v2017.05 and v2017.07 (did not tried previous versions). Any idea of what could possibly be wrong ? Boot log follows. Thank you, Miquèl U-Boot 2017.07-dirty (Jul 12 2017 - 16:12:17 +0200) CPU: Freescale i.MX6DL rev1.1 at 792MHz CPU: Automotive temperature grade (-40C to 125C) at 44C Reset cause: POR Board: MX6Q-Sabreauto revA I2C: ready DRAM: 2 GiB PMIC: PFUZE100 ID=0x10 Flash: 32 MiB NAND: 256 MiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment No panel detected: default to Hannstar-XGA Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5 BOOTP broadcast 6 BOOTP broadcast 7 BOOTP broadcast 8 BOOTP broadcast 9 BOOTP broadcast 10 BOOTP broadcast 11 BOOTP broadcast 12 BOOTP broadcast 13 BOOTP broadcast 14 BOOTP broadcast 15 BOOTP broadcast 16 BOOTP broadcast 17 Retry time exceeded; starting again -- Miquel Raynal, Free Electrons Embedded Linux and Kernel engineering http://free-electrons.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
