On 5/19/2017 1:09 AM , Marek Vasut wrote: > On 05/18/2017 08:26 PM, Rush, Jason A. wrote: >> Add the 'cdns,trigger-address' property to the cadence QSPI device >> node for Altera SoC devices. >> >> Signed-off-by: Jason A. Rush <jason.r...@gd-ms.com> > > +CC Dinh, is that address correct ? I think there was some discussion.
There was some discussion on this before here: https://lists.denx.de/pipermail/u-boot/2017-March/282882.html > Jason, I'd rather prefer if you sent this as a series (with git > send-email) not as a set of separate patches. Also, I'd prefer if you > would just sync up the whole block with standard agreed-upon (linux) > DT bindings and then ev. tweak the driver. > I can't use git send-email from this email account, but I can switch to my personal gmail account which should work. I'll CC my other account and switch to using that from now on. I can try and sync up the DT bindings with Linux, most of the parameters should be easy enough to convert. However, there are two bindings that the u-boot driver defines but Linux looks them up from a table or from querying the flash part ("page-size" and "block-size"), and one binding Linux defines where u-boot calculates ("cdns,read-delay"). It would require significant changes to the u-boot driver to adopt these 3 bindings, would it be acceptable to align all the other DT bindings, with the exception of those 3 bindings? -- Regards, Jason Rush _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
