I have a Guruplug server standard that I would like to upgrade with a newer version of u-boot. Serial output during boot currently shows the following:

----------------cut----------------

U-Boot 2009.11-rc1-00602-g8e6db3d (Dec 24 2009 - 03:11:17)
Marvell-Plug2

SoC:   Kirkwood 88F6281_A0
DRAM:  512 MB
NAND:  512 MiB
In:    serial
Out:   serial
Err:   serial
Net:   egiga0
88E1121 Initialized on egiga0
Hit any key to stop autoboot:  0
Marvell>>

----------------cut----------------

I cloned git://git.denx.de/u-boot-marvell.git and built u-boot off master branch:

make mrproper
make guruplug_config
make CROSS_COMPILE=arm-none-eabi- u-boot.kwb

I wanted to verify that my uboot works properly on my device before committing to flash since I don't have a JTAG available at the moment. However, when I tftp the new u-boot.bin image to the device and issue a "go 0x......" command it never starts (no output after "Starting application at ...".

Also, to do a sanity check I tried to get the standalone hello_world.bin to run in the current u-boot and I am unable to get this to work. I loaded the hellow_world.bin to 0x0c100000 (tftp 0x0c100000 hello_world.bin" and then I issue "go 0x0c100000" and again nothing is printed after the "Starting application at ..." is printed by u-boot.

So my questions are what am I doing wrong and am I using the right repo, branch, and configuration?


Appreciate any pointers.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to