Since the introduction of the pinctrl and clk drivers and the
device tree files, remove unneeded hard coded related code from
the board file.
Signed-off-by: Wenyou Yang <wenyou.y...@atmel.com>
---
Changes in v3: None
Changes in v2: None
board/atmel/at91sam9rlek/at91sam9rlek.c | 19 -------------------
1 file changed, 19 deletions(-)
diff --git a/board/atmel/at91sam9rlek/at91sam9rlek.c
b/board/atmel/at91sam9rlek/at91sam9rlek.c
index 994f246078..0c4d51765e 100644
--- a/board/atmel/at91sam9rlek/at91sam9rlek.c
+++ b/board/atmel/at91sam9rlek/at91sam9rlek.c
@@ -18,10 +18,6 @@
#include <lcd.h>
#include <atmel_lcdc.h>
-#include <atmel_mci.h>
-#if defined(CONFIG_RESET_PHY_R) && defined(CONFIG_MACB)
-#include <net.h>
-#endif
DECLARE_GLOBAL_DATA_PTR;
@@ -159,22 +155,8 @@ void lcd_show_board_info(void)
#endif /* CONFIG_LCD_INFO */
#endif
-#ifdef CONFIG_GENERIC_ATMEL_MCI
-int board_mmc_init(bd_t *bis)
-{
- at91_mci_hw_init();
-
- return atmel_mci_init((void *)ATMEL_BASE_MCI);
-}
-#endif
-
int board_early_init_f(void)
{
- at91_periph_clk_enable(ATMEL_ID_PIOA);
- at91_periph_clk_enable(ATMEL_ID_PIOB);
- at91_periph_clk_enable(ATMEL_ID_PIOC);
- at91_periph_clk_enable(ATMEL_ID_PIOD);
-
return 0;
}
@@ -185,7 +167,6 @@ int board_init(void)
/* adress of boot parameters */
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
- at91_seriald_hw_init();
#ifdef CONFIG_CMD_NAND
at91sam9rlek_nand_hw_init();
#endif
--
2.11.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
