The Pine64 (and all other 64-bit Allwinner boards) need to load an ARM Trusted Firmware image beside the actual U-Boot proper. This can now be easily achieved by using the just extended SPL FIT loading support, so enable it in the Pine64 defconfig. Also add the FIT image as a build target to 64-bit sunxi board to trigger the respective Makefile rules.
Signed-off-by: Andre Przywara <andre.przyw...@arm.com> --- configs/pine64_plus_defconfig | 6 ++++++ include/configs/sunxi-common.h | 4 ++++ 2 files changed, 10 insertions(+) diff --git a/configs/pine64_plus_defconfig b/configs/pine64_plus_defconfig index 92bda60..8a90579 100644 --- a/configs/pine64_plus_defconfig +++ b/configs/pine64_plus_defconfig @@ -3,9 +3,14 @@ CONFIG_ARCH_SUNXI=y CONFIG_MACH_SUN50I=y CONFIG_RESERVE_ALLWINNER_BOOT0_HEADER=y CONFIG_DEFAULT_DEVICE_TREE="sun50i-a64-pine64-plus" +CONFIG_OF_LIST="sun50i-a64-pine64 sun50i-a64-pine64-plus" # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set CONFIG_CONSOLE_MUX=y CONFIG_SPL=y +CONFIG_FIT=y +CONFIG_SPL_FIT=y +CONFIG_SPL_LOAD_FIT=y +CONFIG_SPL_OF_LIBFDT=y # CONFIG_CMD_IMLS is not set # CONFIG_CMD_FLASH is not set # CONFIG_CMD_FPGA is not set @@ -14,3 +19,4 @@ CONFIG_SPL=y # CONFIG_SPL_EFI_PARTITION is not set CONFIG_SUN8I_EMAC=y CONFIG_USB_EHCI_HCD=y +CONFIG_SPL_FIT_GENERATOR="board/sunxi/mksunxi_fit_atf.sh" diff --git a/include/configs/sunxi-common.h b/include/configs/sunxi-common.h index b7eb95e..1982063 100644 --- a/include/configs/sunxi-common.h +++ b/include/configs/sunxi-common.h @@ -32,6 +32,10 @@ # define CONFIG_MACH_TYPE_COMPAT_REV 1 #endif +#ifdef CONFIG_ARM64 +#define CONFIG_BUILD_TARGET "u-boot.itb" +#endif + /* Serial & console */ #define CONFIG_SYS_NS16550_SERIAL /* ns16550 reg in the low bits of cpu reg */ -- 2.8.2 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
