On 13/03/2017 16:51, Tim Harvey wrote: > Signed-off-by: Tim Harvey <thar...@gateworks.com> > --- > drivers/net/Kconfig | 18 ++++++++++++++++++ > 1 file changed, 18 insertions(+) > > diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig > index 078d5a8..a24bb06 100644 > --- a/drivers/net/Kconfig > +++ b/drivers/net/Kconfig > @@ -141,6 +141,24 @@ config MACB > GEM (Gigabit Ethernet MAC) found in some ARM SoC devices. > Say Y to include support for the MACB/GEM chip. > > +config MV88E61XX_SWITCH > + bool "Marvell MV88E61xx Gigabit switch support" > + help > + This driver supports the mv88e6176 and similar switches. > + > +if MV88E61XX_SWITCH > + > +config MV88E61XX_CPU_PORT > + int "CPU Port" > + > +config MV88E61XX_PHY_PORTS > + hex "Bitmask of PHY Ports" > + > +config MV88E61XX_FIXED_PORTS > + hex "Bitmask of PHYless serdes Ports" > + > +endif # MV88E61XX_SWITCH > + > config PCH_GBE > bool "Intel Platform Controller Hub EG20T GMAC driver" > depends on DM_ETH && DM_PCI >
I do not understand this patch: the switch is already added into drivers/net/phy/Kconfig, where it should be, and it should not be in drivers/net/Kconfig where you want to put it. So I am expecting you add if MV88E61XX_SWITCH into drivers/net/phy/Kconfig and not here. Added Joe as network maintainer. Regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
