This patch series adds support SD3.0 and eMMC HS200 modes for ZynqMP. This series also contains changes in mmc and sdhci framework to support SD3.0 and HS200.
Siva Durga Prasad Paladugu (15): mmc: sdhci: Update host capabilities about host controller mmc: Add support for SD3.0 mmc: sdhci: Add SD3.0 support mmc: sdhci: Add support for platform/board specific tuning mmc: sdhci: Add support for platform specific delay mmc: sdhci: Make sdhci_ops of host as modifiable zynqmp: Define routines for mmio write and read mmc: sdhci: zynq: Define private structure arasan_sdhci_priv mmc: sdhci: zynqmp: Add support of SD3.0 mmc: sdhci: Add quirk for 1.8v switching not supported mmc: zynq_sdhci: Update quirk if 1.8v switching not supported mmc: sdhci: Add support for eMMC HS200 mode mmc: sdhci: Update execute tuning and set clock for HS200 mmc: sdhci: zynqmp: Set tapdelays for eMMC HS200 mode mmc: Change frequency while accessing to boot partition arch/arm/cpu/armv8/zynqmp/cpu.c | 51 ++++++ arch/arm/include/asm/arch-zynqmp/sys_proto.h | 3 + board/xilinx/zynqmp/Makefile | 1 + board/xilinx/zynqmp/tap_delays.c | 250 +++++++++++++++++++++++++++ drivers/mmc/mmc-uclass.c | 52 ++++++ drivers/mmc/mmc.c | 218 +++++++++++++++++++++-- drivers/mmc/sdhci.c | 205 +++++++++++++++++++++- drivers/mmc/zynq_sdhci.c | 170 +++++++++++++++++- include/mmc.h | 74 +++++++- include/sdhci.h | 18 +- include/zynqmp_tap_delay.h | 20 +++ 11 files changed, 1040 insertions(+), 22 deletions(-) create mode 100644 board/xilinx/zynqmp/tap_delays.c create mode 100644 include/zynqmp_tap_delay.h -- 2.7.4 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
