Dear Shane Volpe 2009/10/15 Shane Volpe <shanevo...@gmail.com>: > I have a PXA270 system with U-boot v2009.08 installed, currently this > system is successfully using the U-boot mmc interface (legacy) . > However, after looking through the u-boot source code, I see there is > a new mmc interface (CONFIG_GENERIC_MMC), should I be using the > generic mmc interface? I have tried it but it does not seem to work, > I'm assuming that it probably requires initialization of the MMC > hardware in the board files whereas in the legacy mmc system that was > done by the (legacy_mmc_init) board specific mmc (pxa_mmc.c) code. > > Questions regarding the new GENERIC_MMC interface: > 1.) Is there any documentation in place (or can someone send me off a > quick reply) on how to set up the generic mmc driver with a board? > 2.) Is it ready (recommended) to use or is it still under heavy development?
generic mmc interface is ready > 3.) Does it support SDHC or just SD? support both of them > > Regards, > Shane > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > Thanks Minkyu Kang -- from. prom. www.promsoft.net _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
