U-boot for Marvell Kirkwood boards no longer work after the EABI changes introduced in commit f772acf8a584067033eff1e231fcd1fb3a00d3d9. This turns out to be caused by a stack alignment issue. The armv5te instructions ldrd/strd instructions require 8-byte alignment to work properly (otherwise undefined behavior), and start.S gave the stack a 12-byte alignment.
Tested on an OpenRD base board, where both printouts and ubifs stuff now works. Signed-off-by: Simon Kagstrom <simon.kagst...@netinsight.net> --- ChangeLog: v2: Update after Andrews comments * Mask away the low address bits to get 16-byte alignment cpu/arm926ejs/start.S | 5 ++++- 1 files changed, 4 insertions(+), 1 deletions(-) diff --git a/cpu/arm926ejs/start.S b/cpu/arm926ejs/start.S index 8043322..cd3a6bd 100644 --- a/cpu/arm926ejs/start.S +++ b/cpu/arm926ejs/start.S @@ -171,7 +171,10 @@ stack_setup: #ifdef CONFIG_USE_IRQ sub r0, r0, #(CONFIG_STACKSIZE_IRQ+CONFIG_STACKSIZE_FIQ) #endif - sub sp, r0, #12 /* leave 3 words for abort-stack */ + sub r0, r0, #12 /* leave 3 words for abort-stack and */ + mov r1, #7 /* 8-byte align stack for ldrd/strd */ + and r1, r0 + sub sp, r0, r1 clear_bss: ldr r0, _bss_start /* find start of bss segment */ -- 1.6.0.4 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot