Add a new Kconfig option to allow PCI drivers to be used in SPL.
Signed-off-by: Simon Glass <s...@chromium.org>
---
common/spl/Kconfig | 9 +++++++++
drivers/Makefile | 1 +
2 files changed, 10 insertions(+)
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 3c33c9e..0c83ff1 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -378,6 +378,15 @@ config SPL_ONENAND_SUPPORT
load U-Boot from supported devices. This enables the drivers in
drivers/mtd/onenand as part of an SPL build.
+config SPL_PCI_SUPPORT
+ bool "Support PCI drivers"
+ depends on SPL
+ help
+ Enable support for PCI in SPL. For platforms that need PCI to boot,
+ or must perform some init using PCI in SPL, this provides the
+ necessary driver support. This enables the drivers in drivers/pci
+ as part of an SPL build.
+
config SPL_POST_MEM_SUPPORT
bool "Support POST drivers"
depends on SPL
diff --git a/drivers/Makefile b/drivers/Makefile
index b4fd0c4..ae3c76a 100644
--- a/drivers/Makefile
+++ b/drivers/Makefile
@@ -33,6 +33,7 @@ obj-$(CONFIG_SPL_DMA_SUPPORT) += dma/
obj-$(CONFIG_SPL_ETH_SUPPORT) += net/
obj-$(CONFIG_SPL_ETH_SUPPORT) += net/phy/
obj-$(CONFIG_SPL_USBETH_SUPPORT) += net/phy/
+obj-$(CONFIG_SPL_PCI_SUPPORT) += pci/
obj-$(CONFIG_SPL_MUSB_NEW_SUPPORT) += usb/musb-new/
obj-$(CONFIG_SPL_USBETH_SUPPORT) += usb/gadget/
obj-$(CONFIG_SPL_WATCHDOG_SUPPORT) += watchdog/
--
2.8.0.rc3.226.g39d4020
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
