Enable use of the instruction cache immediately after it has been
initialised. This will only take effect if U-Boot was linked to run from
kseg0 rather than kseg1, but when this is the case the data cache
initialisation code will run cached & thus significantly faster.
Signed-off-by: Paul Burton <paul.bur...@imgtec.com>
---
Changes in v3: None
Changes in v2: None
arch/mips/cpu/start.S | 8 --------
arch/mips/lib/cache_init.S | 13 +++++++++++++
2 files changed, 13 insertions(+), 8 deletions(-)
diff --git a/arch/mips/cpu/start.S b/arch/mips/cpu/start.S
index fc6dd66..827a544 100644
--- a/arch/mips/cpu/start.S
+++ b/arch/mips/cpu/start.S
@@ -12,10 +12,6 @@
#include <asm/regdef.h>
#include <asm/mipsregs.h>
-#ifndef CONFIG_SYS_MIPS_CACHE_MODE
-#define CONFIG_SYS_MIPS_CACHE_MODE CONF_CM_CACHABLE_NONCOHERENT
-#endif
-
#ifndef CONFIG_SYS_INIT_SP_ADDR
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_SDRAM_BASE + \
CONFIG_SYS_INIT_SP_OFFSET)
@@ -154,10 +150,6 @@ reset:
PTR_LA t9, mips_cache_reset
jalr t9
nop
-
- /* ... and enable them */
- li t0, CONFIG_SYS_MIPS_CACHE_MODE
- mtc0 t0, CP0_CONFIG
#endif
/* Set up temporary stack */
diff --git a/arch/mips/lib/cache_init.S b/arch/mips/lib/cache_init.S
index bc8ab27..974dfe9 100644
--- a/arch/mips/lib/cache_init.S
+++ b/arch/mips/lib/cache_init.S
@@ -172,6 +172,19 @@ LEAF(mips_cache_reset)
cache_loop t0, t1, t8, INDEX_STORE_TAG_I
#endif
+ /* Enable use of the I-cache by setting Config.K0 */
+ sync
+ mfc0 t0, CP0_CONFIG
+ li t1, CONFIG_SYS_MIPS_CACHE_MODE
+#if __mips_isa_rev >= 2
+ ins t0, t1, 0, 3
+#else
+ ori t0, t0, CONF_CM_CMASK
+ xori t0, t0, CONF_CM_CMASK
+ or t0, t0, t1
+#endif
+ mtc0 t0, CP0_CONFIG
+
/*
* then initialize D-cache.
*/
--
2.10.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
