On Mon, 2016-09-12 at 12:18 -0600, Stephen Warren wrote:
> On 09/09/2016 10:10 AM, Marcel Ziswiler wrote:
> >
> > Without this patch the following error will be shown:
> >
> > stdio_add_devices: Video device failed (ret=-22)
> >
> > As commit ec5507707a1d1e84056a6c864338f95f6118d3ca (video: tegra:
> > Move
> > to using simple-panel and pwm-backlight) states the Colibri T20
> > needs
> > updating too which this patch finally attempts doing.
> >
> > Please note that the current U-Boot implementation requires a dummy
> > GPIO e.g. for a fixed backlight regulator to be explicitly defined
> > in
> > order to work unlike in the Linux kernel where this is taken care
> > of
> > automatically.
> The binding documentation does state that the power supply is
> mandatory.
Yes, of course.
> > diff --git a/arch/arm/dts/tegra20-colibri.dts
> > b/arch/arm/dts/tegra20-colibri.dts
> >
> > + regulators {
> > + compatible = "simple-bus";
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > +
> > + reg_dummy: regulator@0 {
> Why call this a dummy? This is a real regulator that describes the
> power
> supply to the backlight. Even if there's no SW control over the power
> to
> the backlight, there is still a (fixed) power source, and this DT
> node
> represents that power source.
OK.
> > + compatible = "regulator-fixed";
> > + reg = <0>;
> > + regulator-name = "Dummy";
> > + /* Dummy N/C */
> > + gpio = <&gpio TEGRA_GPIO(V, 7)
> > GPIO_ACTIVE_HIGH>;
> This is wrong. If that GPIO isn't actually part of the backlight, the
> DT
> should not say that it is. The gpio property is optional according
> to
> the DT binding documentation, so this shouldn't be needed.
Well, I guess then it's lying. If I leave it away I get the following:
stdio_add_devices: Video device failed (ret=-38)
And it won't quite work.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
