On 09/01/2016 04:46 PM, Max Ruttenberg wrote: > Hi, Hi,
> I'm find myself clueless in regards to writing a driver for an FPGA over a > PCI bus. This U-Boot is running on an NXP t102xrdb board family, if that > matters. > > The documentation in doc/driver-model/pci-info.txt mentions that I can use > a macro named U_BOOT_PCI_DEVICE as alternative to listing my device in a > device tree. > > I found an example of this in drivers/net/e1000.c, and I tried to follow it > as much as was applicable (this is an ethernet driver, which my driver is > not). > > But when U-Boot starts up, my "bind" function is never called, even though > I can tell that my device with the corresponding vendor and device id is > detected using the "pci [bus]" command. > > I appreciate any help I can get. Switching to the u-boot list and Ccing Simon. What is loaded in your FPGA ? -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
