On 08/24/2016 12:39 PM, Sriram Dash wrote:
> Currently the controller by default enables the Receive Detect feature in P3
> mode in USB 3.0 PHY. However, USB 3.0 PHY does not reliably support receive
> detection in P3 mode.
> Enabling the USB3 controller to configure USB in P2 mode whenever the Receive
> Detect feature is required.
>
> Signed-off-by: Sriram Dash <sriram.d...@nxp.com>
> Signed-off-by: Rajesh Bhagat <rajesh.bha...@nxp.com>
> ---
> Changes in v2:
> - Do Soc ver checking for applying erratum
>
> drivers/usb/common/fsl-errata.c | 26 ++++++++++++++++++++++++++
> drivers/usb/host/xhci-dwc3.c | 5 +++++
> drivers/usb/host/xhci-fsl.c | 8 ++++++++
> include/fsl_usb.h | 1 +
> include/linux/usb/dwc3.h | 2 ++
> 5 files changed, 42 insertions(+)
>
> diff --git a/drivers/usb/common/fsl-errata.c b/drivers/usb/common/fsl-errata.c
> index 183bf2b..f2bffba 100644
> --- a/drivers/usb/common/fsl-errata.c
> +++ b/drivers/usb/common/fsl-errata.c
> @@ -190,4 +190,30 @@ bool has_erratum_a008751(void)
> return false;
> }
>
> +bool has_erratum_a010151(void)
> +{
> + u32 svr = get_svr();
> + u32 soc = SVR_SOC_VER(svr);
> +
> + switch (soc) {
> +#ifdef CONFIG_ARM64
> + case SVR_LS2080A:
> + case SVR_LS2085A:
> + case SVR_LS1046A:
> + case SVR_LS1012A:
> + return IS_SVR_REV(svr, 1, 0);
> + case SVR_LS1043A:
> + return IS_SVR_REV(svr, 1, 0) || IS_SVR_REV(svr, 1, 1);
> +#endif
> +#ifdef CONFIG_LS102XA
> + case SOC_VER_LS1020:
> + case SOC_VER_LS1021:
> + case SOC_VER_LS1022:
> + case SOC_VER_SLS1020:
> + return IS_SVR_REV(svr, 2, 0);
> +#endif
> + }
Is the ifdef really needed ?
--
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
