This e,g is wrong. Maximum/minimum e.g values are swapped each other. Signed-off-by: Jaehoon Chung <jh80.ch...@samsung.com> --- include/dwmmc.h | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/include/dwmmc.h b/include/dwmmc.h index 6aebe96..164d1dc 100644 --- a/include/dwmmc.h +++ b/include/dwmmc.h @@ -256,8 +256,8 @@ static inline u8 dwmci_readb(struct dwmci_host *host, int reg) * @name: Device name (normally dev->name) * @buswidth: Bus width (in bits, such as 4 or 8) * @caps: Host capabilities (MMC_MODE_...) - * @max_clk: Maximum supported clock speed in HZ (e.g. 400000) - * @min_clk: Minimum supported clock speed in HZ (e.g. 150000000) + * @max_clk: Maximum supported clock speed in HZ (e.g. 150000000) + * @min_clk: Minimum supported clock speed in HZ (e.g. 400000) */ void dwmci_setup_cfg(struct mmc_config *cfg, const char *name, int buswidth, uint caps, u32 max_clk, u32 min_clk); @@ -286,8 +286,8 @@ int dwmci_bind(struct udevice *dev, struct mmc *mmc, struct mmc_config *cfg); * This is used when you are not using CONFIG_BLK. Convert your driver over! * * @host: DWMMC host structure - * @max_clk: Maximum supported clock speed in HZ (e.g. 400000) - * @min_clk: Minimum supported clock speed in HZ (e.g. 150000000) + * @max_clk: Maximum supported clock speed in HZ (e.g. 150000000) + * @min_clk: Minimum supported clock speed in HZ (e.g. 400000) * @return 0 if OK, -ve on error */ int add_dwmci(struct dwmci_host *host, u32 max_clk, u32 min_clk); -- 1.9.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot