Otherwise, ocassionally see errors like this: Flashing sparse image at offset 2078720 Flashing Sparse Image sdhci_send_command: Timeout for status update! mmc fail to send stop cmd write_sparse_image: Write failed, block #2181088 [0]
This does not affect the actual writing speed, which is controlled by the default value: CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT It only increases the retries when reading: SDHCI_INT_STATUS to avoid the timeout error. Signed-off-by: Steve Rae <steve....@raedomain.com> --- as per the discussion in: http://lists.denx.de/pipermail/u-boot/2016-June/258966.html this supercedes: http://patchwork.ozlabs.org/patch/615994/ drivers/mmc/sdhci.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index 5c71ab8..aa4cd4f 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -127,6 +127,7 @@ static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data, #define CONFIG_SDHCI_CMD_MAX_TIMEOUT 3200 #endif #define CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT 100 +#define CONFIG_SDHCI_READ_STATUS_TIMEOUT 1000 static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, struct mmc_data *data) @@ -243,9 +244,9 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, if (stat & SDHCI_INT_ERROR) break; } while (((stat & mask) != mask) && - (get_timer(start) < CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT)); + (get_timer(start) < CONFIG_SDHCI_READ_STATUS_TIMEOUT)); - if (get_timer(start) >= CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT) { + if (get_timer(start) >= CONFIG_SDHCI_READ_STATUS_TIMEOUT) { if (host->quirks & SDHCI_QUIRK_BROKEN_R1B) return 0; else { -- 1.8.5 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
