twister board was not updated after changing SPL defines, resulting in a broken board.
Signed-off-by: Stefano Babic <sba...@denx.de> --- include/configs/tam3517-common.h | 16 ++++++++++++++++ 1 file changed, 16 insertions(+) diff --git a/include/configs/tam3517-common.h b/include/configs/tam3517-common.h index efdc706..73ff416 100644 --- a/include/configs/tam3517-common.h +++ b/include/configs/tam3517-common.h @@ -207,6 +207,8 @@ #define CONFIG_SPL_LIBCOMMON_SUPPORT #define CONFIG_SPL_LIBDISK_SUPPORT #define CONFIG_SPL_I2C_SUPPORT +#define CONFIG_SPL_MMC_SUPPORT +#define CONFIG_SPL_FAT_SUPPORT #define CONFIG_SPL_LIBGENERIC_SUPPORT #define CONFIG_SPL_SERIAL_SUPPORT #define CONFIG_SPL_GPIO_SUPPORT @@ -219,12 +221,26 @@ #define CONFIG_SPL_TEXT_BASE 0x40200000 /*CONFIG_SYS_SRAM_START*/ #define CONFIG_SPL_MAX_SIZE (54 * 1024) /* 8 KB for stack */ +#define CONFIG_SPL_STACK LOW_LEVEL_SRAM_STACK #define CONFIG_SYS_SPL_MALLOC_START 0x8f000000 #define CONFIG_SYS_SPL_MALLOC_SIZE 0x80000 #define CONFIG_SPL_BSS_START_ADDR 0x8f080000 /* end of RAM */ #define CONFIG_SPL_BSS_MAX_SIZE 0x80000 +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300 /* address 0x60000 */ +#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1 +#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img" + +/* FAT */ +#define CONFIG_SPL_FS_LOAD_KERNEL_NAME "uImage" +#define CONFIG_SPL_FS_LOAD_ARGS_NAME "args" + +/* RAW SD card / eMMC */ +#define CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR 0x900 /* address 0x120000 */ +#define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTOR 0x80 /* address 0x10000 */ +#define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTORS 0x80 /* 64KiB */ + /* NAND boot config */ #define CONFIG_SYS_NAND_BUSWIDTH_16BIT #define CONFIG_SYS_NAND_PAGE_COUNT 64 -- 1.9.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
