On Wed, 09 Sep 2009 20:52 +0200, Konrad Mattheis wrote : > Hi Albin, > > so I describe you what I did. > > Downloaded u-boot 2009.08 > > changed: > >#if defined(CONFIG_HAS_DATAFLASH) > to: > >#if defined(CONFIG_HAS_DATAFLASH) || defined(CONFIG_ATMEL_SPI) > > applied Patch: > http://lists.denx.de/pipermail/u-boot/2009-September/060053.html > > then applied Patch V3: from mail > > added to:include/config/at91sam9260ek.h > > #define CONFIG_CMD_MMC 1 > #define CONFIG_MMC 1 > #define CONFIG_ATMEL_MCI > > compiled and the on the at91sam9g20ek > I can start a normal kernel,... > but if I write mmc init I get the following error:
Ok, so that's what I thought: you're missing a call to at91_mciX_hw_init in your board init code. This function assigns the correst I/O pins to the MCI controller and takes care of enabling the clock. Please have a look at at91_mciX_hw_init cpu/arm926ejs/at91/at91sam9260_devices.c to see what arguments the function expects. > >mmc: clock 150000 too low; setting CLKDIV to 255 > >No MMC card found > > After this I tried to download git://git.denx.de/u-boot.git and then I could > not apply the patches. > I always got this message: > Reversed (or previously applied) patch detected! Assume -R? [n] > Did you already applied the patches to the git repository? The CONFIG_ATMEL_SPI change is in mainline, yes. Other parts of the patch aren't. Regards, -- Albin Tonnerre, Free Electrons Kernel, drivers and embedded Linux development, consulting, training and support. http://free-electrons.com _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
