Dear "Hu Mingkai-B21284",

In message 
<73839b4a0818e747864426270ac332c30447e...@zmy16exm20.fsl.freescale.net> you 
wrote:
>
> > It should be enough to pass the make target name to the 
> > mkconfig script resp. the board config file, i. e. in this 
> > case either "CONFIG_MPC8536DS_NAND" or 
> > "CONFIG_MPC8536DS_NAND_36BIT". The rest of the 
> > scripting/decision making can then be done in the board config file.
> > 
>
> Thanks for your replay, but I'm not totally catch on you.
> "the board config file" in your words refer to board/*/config.mk, right?

No, with "board config file" I mean include/configs/*.h

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Q: Why do PCs have a reset button on the front?
A: Because they are expected to run Microsoft operating systems.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to